We sincerely welcome you to contact us through the hotline and other instant messaging methods. Whether it's project consultation or feedback, we will serve you in the fastest way and spare no effort to save time for customers.
OBORTS Company, Opposite the residence of old General Mambou, Near Dragage, Bastos, Yaoundé, Cameroon
Email: [email protected]
Aug 15, 2012· Cone crusher parts It breaks the rocks by squeezing it between the gyrating spindles. These spindles are fully covered with resistant mantle and a manganese bowl liner covers the hopper. Rocks get squeezed at the same moment when it enters in between the bowl liner and mantle.
An impact crusher can be further classified as Horizontal impact crusher (HSI) and vertical shaft impact crusher (VSI) based on the type of arrangement of the impact rotor and shaft. Horizontal shaft impact crusher These break rock by impacting the rock with hammers/blow bars that are fixed upon the outer edge of a spinning rotor.
Horizontal Shaft Impactors consist of a hopper, two or three aprons, a rotor, and blow bars or hammers. Essentially, large products are fed into the hopper where they come into contact with hammers or blow bars to a spinning rotor which crushes the material into smaller pieces.
The cone crusher is a modified gyratory crusher. The essential difference is that the shorter spindle of the cone crusher is not suspended, as in the gyratory, but is supported in a curved, universal bearing below the gyratory head or cone (Figure 8.2). Power is transmitted from the source to the countershaft to a V-belt or direct drive.
The Kodiak® Plus Cone Crusher meets coarse and fine crushing application requirements, and offers on- Accommodating three- or four-blow bar configurations, Andreas Series Horizontal Shaft Impactors (HSI) offer pollution, electrical wiring, etc. Compliance with these statutes and regulations is the responsibility of the user and will be